Frequently Asked Forum Questions

From Wicked Edge Wiki
(Difference between revisions)
Jump to: navigation, search
 
Line 23: Line 23:
  
 
* [http://www.wickededgeusa.com/index.php?option=com_kunena&func=view&catid=6&id=1888&Itemid=63 Linkage play]
 
* [http://www.wickededgeusa.com/index.php?option=com_kunena&func=view&catid=6&id=1888&Itemid=63 Linkage play]
 +
  
 
===Q: I’ve got a narrow knife. When I try to sharpen this knife, a stone hits the top of the vise or the top screw in the vise===
 
===Q: I’ve got a narrow knife. When I try to sharpen this knife, a stone hits the top of the vise or the top screw in the vise===

Latest revision as of 11:21, 15 April 2013

This page contains questions frequently asked on the Wicked Edge forum as well as answers people have given.


Contents


Q: The sharpening angle on one side of the blade is different from the other side. Or: how do I clamp a knife horizontally?

A: If you are just concerned with sharpness, it does not matter if the sharpening angle on one side of the blade is a bit different from that on the other side. However, for aesthetic purposes or in order for the sharpening to be repeatable, it may matter.

You need to mount the knife in the vise completely upright. If you have trouble mounting a fully flat ground (FFG) blade, use a piece of chamois or foam tape to clamp the blade.

Forum links:


Q: I’ve got a narrow knife. When I try to sharpen this knife, a stone hits the top of the vise or the top screw in the vise

A: Try to sharpen the knife at a higher angle. Alternatively, try to clamp the knife higher in the clamp. To mount the knife horizontally, put the height key in the top holes and use one or more matches to raise the knife.

Forum links:


Q: How do I sharpen a Japanese knife, single-bevel knife, yanagiba or deba?

A: Some tips:

  • Don't use coarse stones in order to prevent chipping during sharpening
  • Consider a microbevel on a steep edge
  • Use waterstones to enhance the kazumi haze
  • Don't sharpen the "other" side of a single-beveled blade on the WEPS. Just move this side (nearly) horizontally over a fine stone to remove the burr after sharpening the beveled side on the WEPS.

Forum links:


Q: How do I sharpen a Spyderco knife where the diamond stones don't reach into that little nook formed by the finger choil?

A: Grind the plastic shoulders from the stones. Or use different stones than the stock diamond stones (for example Choseras). Clay has suggested removing the diamond plates from the paddles and then add a layer of some material between them.

Forum links:

Personal tools
Namespaces
Variants
Actions
Navigation
Toolbox