Welcome, Guest
Username: Password: Remember me

TOPIC: Today at the Whole Life Market sharpening

Re: UPDATE - tip fine- sharpening in progress 9 months 3 weeks ago #12290

  • LeoBarr
  • LeoBarr's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 600
  • Thank you received: 197
  • Karma: 32
Looking good although I would definitely microbevel it at 16Ëš which is the factory angle also bear in ming it has a Rockwell hardness of around 60 or more so 12-13Ëš will be prone to chipping and this will have the benefit of been nicely thinned since the knife has been sharpened quite a lot by the appearance of the edge.
ScreenShot2013-06-28at19.50.41.png
The administrator has disabled public write access.

Re: UPDATE - tip fine- sharpening in progress 9 months 3 weeks ago #12297

  • tuffybraithwaite
  • tuffybraithwaite's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 329
  • Thank you received: 97
  • Karma: 23
LeoBarr wrote:
Looking good although I would definitely microbevel it at 16Ëš which is the factory angle also bear in ming it has a Rockwell hardness of around 60 or more so 12-13Ëš will be prone to chipping and this will have the benefit of been nicely thinned since the knife has been sharpened quite a lot by the appearance of the edge.
ScreenShot2013-06-28at19.50.41.png
.
.
.
I Made it higher degree - 18.50
.
.

.

.
.
.
.
.
<"))))><(
The administrator has disabled public write access.

Re: UPDATE - tip fine- sharpening in progress 9 months 3 weeks ago #12299

  • LeoBarr
  • LeoBarr's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 600
  • Thank you received: 197
  • Karma: 32
Look sweet they are so sharp I threw away the box since once taking the clip off it to get it out; the knife leapt up did a 270Ëš straight onto my finger drew blood it was the christening so I have made leather sheaths for my really sharp knives .
The administrator has disabled public write access.
Time to create page: 0.135 seconds