Welcome, Guest
Username: Password: Remember me

TOPIC: Mounting question about hawk blades

Mounting question about hawk blades 2 years 1 month ago #4945

  • KenBuzbee
  • KenBuzbee's Avatar
  • Platinum Boarder
  • Posts: 397
  • Thank you received: 110
  • Karma: 22
So I've come to realize that some of my odder shaped blades require "non standard" mounting techniques (to keep the bevel anywhere near uniform) and that's fine. I usually figure them out. But I haven't tried a hawk shaped blade yet and was wondering if anyone had any pointers?

These Spydercos I have in both PE and SE. I'm mostly asking about the PEs at this point but SE info is welcome too. I currently do all four of these on a Sharpmaker, FYI.

sorry about the lousy pic;)

It seems if I try to mount so the tip and heel are level the heel and tip will get a wider bevel than the middle. If I tip it either way, I can go wider heel to narrower tip, or visa versa. Any way to mount it so they are equal?


The administrator has disabled public write access.
Time to create page: 0.139 seconds