Welcome, Guest
Username: Password: Remember me

TOPIC: Mounting question about hawk blades

Mounting question about hawk blades 1 year 7 months ago #4945

  • KenBuzbee
  • KenBuzbee's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 397
  • Thank you received: 110
  • Karma: 22
So I've come to realize that some of my odder shaped blades require "non standard" mounting techniques (to keep the bevel anywhere near uniform) and that's fine. I usually figure them out. But I haven't tried a hawk shaped blade yet and was wondering if anyone had any pointers?

These Spydercos I have in both PE and SE. I'm mostly asking about the PEs at this point but SE info is welcome too. I currently do all four of these on a Sharpmaker, FYI.


sorry about the lousy pic;)

It seems if I try to mount so the tip and heel are level the heel and tip will get a wider bevel than the middle. If I tip it either way, I can go wider heel to narrower tip, or visa versa. Any way to mount it so they are equal?

Thanks,

Ken
玉鋼
The administrator has disabled public write access.
Time to create page: 0.117 seconds