Welcome, Guest
Username Password: Remember me
Forgot your password? Forgot your username?
Wicked Edge
Main Forum
Techniques and Sharpening Strategies
Basic Techniques and Sharpening Strategies

Thumb screws for arms loosening themselves
(1 viewing) (1) Guest
Reply Topic
New Topic
  • Page:
  • 1
  • 2

TOPIC: Thumb screws for arms loosening themselves

Re: Thumb screws for arms loosening themselves 2 months, 1 week ago #9759

  • CraigDavis
  • OFFLINE
  • Junior Boarder
  • Posts: 21
  • Karma: 1
I've got the upgraded arms that will take a hex key. Tonight I sharpened four knives and had one arm loosen up once (for the first time).

I will say this, with my limited experience with this system, there is a way to tighten these screws. You must "find" the detent while turning the screw. I mean "find" the detent by moving the arm slightly while turning the screw. If the screw is not centered on the detent it will loosen up.
Reply Quote
The following user(s) said Thank You: cbwx34

Re: Thumb screws for arms loosening themselves 2 months, 1 week ago #9764

  • cbwx34
  • OFFLINE
  • Moderator
  • Staring contest...
  • Posts: 848
  • Karma: 80
blacksheep25 wrote:
If only the tip is touching, you'd probably want to file a really small amount off the very point so that it makes more contact.


I wonder if this might also rough up the end a bit, resulting in a more secure grip?

CraigDavis wrote:
I will say this, with my limited experience with this system, there is a way to tighten these screws. You must "find" the detent while turning the screw. I mean "find" the detent by moving the arm slightly while turning the screw. If the screw is not centered on the detent it will loosen up.


Good tip!
Reply Quote
Reply Topic
New Topic
  • Page:
  • 1
  • 2
Wicked Edge
Main Forum
Techniques and Sharpening Strategies
Basic Techniques and Sharpening Strategies
Time to create page: 1.17 seconds