Welcome, Guest
Username Password: Remember me
Forgot your password? Forgot your username?
Wicked Edge
Main Forum
Suggestion Box

Low Angle Accessory
(1 viewing) (1) Guest
This is the optional forum header for the Suggestion Box.
Reply Topic
New Topic

TOPIC: Low Angle Accessory

Re: Low Angle Accessory 10 months, 3 weeks ago #4252

  • mamun1024
  • OFFLINE
  • Fresh Boarder
  • Posts: 12
  • Karma: 4
Bump for an update.

I REALLY REALLY REALLY, REALLY need to get 10° angle for some of my favorite blades. Clay, please don't forget about this.
Reply Quote
The following user(s) said Thank You: Salguod

Re: Low Angle Accessory 10 months, 3 weeks ago #4253

  • wickededge
  • OFFLINE
  • Administrator
  • Posts: 1468
  • Karma: 75
I'm actively working on it!

MonteAhmed wrote:
Bump for an update.

I REALLY REALLY REALLY, REALLY need to get 10° angle for some of my favorite blades. Clay, please don't forget about this.
--Clay Allison
Reply Quote
The following user(s) said Thank You: mamun1024

Re: Low Angle Accessory 10 months, 3 weeks ago #4259

  • KenBuzbee
  • OFFLINE
  • Platinum Boarder
  • Posts: 331
  • Karma: 17
wickededge wrote:
I'm actively working on it!



Thank you!

Ken
玉鋼
Reply Quote

Re: Low Angle Accessory 10 months, 3 weeks ago #4260

  • Salguod
  • OFFLINE
  • Senior Boarder
  • Posts: 59
  • Karma: 8
Me too! I hope the low angle accessory comes out soon!

Doug
Reply Quote

Re: Low Angle Accessory 10 months, 3 weeks ago #4265

  • BassLakeDan
  • OFFLINE
  • Expert Boarder
  • Posts: 116
  • Karma: 19
... ..
well, of course, this is not what you guys really have in mind, but I did rig this up out of some old steel foundation straps.. Doesn't work too bad for resharpening your old utility box knifes ! Actually, I was working on this blade for a reason, and if it goes well I will fill in the missing details later.
Reply Quote

Re: Low Angle Accessory 10 months, 3 weeks ago #4268

  • KenBuzbee
  • OFFLINE
  • Platinum Boarder
  • Posts: 331
  • Karma: 17
Nice Dan. I was wondering about this exact kind of thing. My thoughts were two metal plates with four tapped holes each. Bolt them to the alignment holes in the jaws. Might need a shim between them for stability (about the thickness of the blade) Insert the blade, lightly tighten the top screw, insert the shim and tighten the bottom screw. Seemed like it would work.

I'll be interested in updates to our "project"

Ken
玉鋼
Reply Quote
Reply Topic
New Topic
Wicked Edge
Main Forum
Suggestion Box
Time to create page: 0.74 seconds