If I was using the progression of diamonds through 1k would I get 'much of' a different result using (next after 1k) the Chosera 10k vs the new Micro Ceramics? If so, how... why?
Thanks--
Krystina

Clay,
I have a customer who is waiting for a purchased WEPS and asked me if I had PDF copy of template for drilling base so he could get this done while waiting...
Thanks,
K--

will do and f/u with results!
Tx--

Clay,
I have followed your instructions above and cannot seem to get these Kyocera blades razor sharp!?! They were very (VERY) dull when they came to me; the progression I went thru is as follows... 100/200, 400/600 and then 800/1000.
Never did pull a burr at start (w/ 100), thought maybe since ceramic, burr would not form?
Shall I go (back) to 50/80?
I believe my pressure is OK... not too light.
THANKS--

Clay did you sharpen the 'tang' (curve up). If not I am curious to know .