Manufacturer Model Blade Length Thickness Steel Hardness Recommended Angle Recommended Finish Depth AlignmentIntent
Bark River STS-5 5.5 inches .270 inches 154 CM Stainless Ste 58 16 degrees ceramics and strops with 5 and 3.5 micron pastes bottom C Tactical/Survival
 
Authors Comments:Basically a belly to belly fighter but can be used as a survival knife. LJM
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author:
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Leatherman Super Tool (original) 3" n/a n/a (cheap) n/a 22 1000# then 5-3.5 leather strops spine only in vice A .5 EDC
 
Authors Comments:set blade high in vice, only the square part of spine in vice
Angle/Finish Tried with Ratings
Setting 1:
lower in vice with depth key at high

Setting 2:
22 deg, 1000#, 3.5u strops, depth higher, see comm

Setting 3:


Setting 4:


Setting 5:


Author: Geocyclist
Rating:
4
Rating:
6
Rating:
Rating:
Rating:
Spyderco Superleaf CF 3.438" .156" VG-10 unknown 15 3.5um Bottom. B
 
Authors Comments:
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author:
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Smith SWBLOP3 3.4 ? 4034 ? 20 3.5 mu ? B ever day use
 
Authors Comments:
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: MelvinSharp
Rating:
Rating:
Rating:
Rating:
Rating:
Remington Swift-Lokt Assited Opening Folder 3.125 inches .134 inches 440A 56 17 degrees per side ceramics and strops Top B-1 general use EDC, good in the kitchen, backyard or
 
Authors Comments:My wife loves this knife. It takes a good edge and is easy to resharpen. It gets a lot of use by everyone. LJM
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: Leo James Mitchell
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Spyderco Tenacious 3.39" 0.118" 8Cr13MoV HRC 58-59 15 0.5um 2nd B.5
 
Authors Comments:Shaving sharp and mirror polish after finishing with the 1/0.5um diamond spray on leather
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: MartinL1
Rating:
Rating:
Rating:
Rating:
Rating:
Fallkniven TK-1 4 inches .18 inches 3G laminated powder 62 21 degrees ceramics and strops with 5 and 3.5 micron pastes Top B.4 bushcraft
 
Authors Comments: LJM
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author:
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Rating:
1
Cold Steel Twist Master 3.5 ? Carbon V ? 17.3 8k Naniwa super stone Upper holes B EDC
 
Authors Comments:Diamond 400-1000. Ceramic 1200-0.6. Naniwa 8k. Bought several of these as close outs/ factory 2nds About 20 years ago. Takes a nice edge easily and keeps it well. Rusts easily.
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: Mikedoh
Rating:
Rating:
Rating:
Rating:
Rating:
SOG Twitch II 2.68" .1" AUS-8 HRC 57-58 22 3.5u Top A.5
 
Authors Comments:My progression was 800 to 1600 ceramics. Then 14, 10, 5, 3.5u strops. 100 strokes with each strop then would flip strops end for end at 50 so the whole strop would get worn evenly
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: wickededge
Rating:
Rating:
Rating:
Rating:
Rating:
SOG Twitch XL 3.25 0.13 AUS-8 RC 57-58 22 3.5u Top A.5 EDC
 
Authors Comments:
Angle/Finish Tried with Ratings
Setting 1:


Setting 2:


Setting 3:


Setting 4:


Setting 5:


Author: SleeplessJunkie
Rating:
Rating:
Rating:
Rating:
Rating:


Page 16 of 18 Results 151 - 160 of 172