Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: Chosera Stone Use

Re: Chosera Stone Use 1 year 1 month ago #11374

  • CliffordBegnaud
  • CliffordBegnaud's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 15
  • Thank you received: 3
  • Karma: 0
I'll share a tip I got from Bob Nash of Oldawan; when switching from diamond to chosera, start at the same grit. For example, my smallest grit diamond stone is 600, I then go directly to 600 Chosera. The chosera cleans up the inconsistent scratch pattern of the diamond stone and provides a very nice even scratch pattern on which to proceed. The 600 does it's work very quickly, so you don't spend a lot of time trying to remove large scratches with your finer stones. This trick has greatly reduced the amount of time it takes to sharpen a knife, with improved results. The 600 chosera is aggressive, it's one of my favorite stones.
Contact Bob, or Clay about a handle set with just the 600 grit chosera stones, not very expensive.
best regards,
Cliff
The administrator has disabled public write access.
The following user(s) said Thank You: cbwx34

Re: Chosera Stone Use 1 year 1 month ago #11377

  • KenBuzbee
  • KenBuzbee's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 397
  • Thank you received: 110
  • Karma: 22
I actually go further than that. I go down a level. If my finest diamond was a 600, I'd back up to 400 Chosera.

Ken
玉鋼
The administrator has disabled public write access.
The following user(s) said Thank You: cbwx34
  • Page:
  • 1
  • 2
Time to create page: 0.116 seconds