Welcome, Guest
Username: Password: Remember me

TOPIC: What's the smallest blade you've done on the WEPS?

What's the smallest blade you've done on the WEPS? 3 years 3 weeks ago #574

  • dschur
  • dschur's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 46
  • Thank you received: 10
  • Karma: 10
Just wondering what the smallest blade is you've done on the Wicked Edge?

I just got 2 CRKT Ritter RSK MK5's that I was going to toss into some kits. The factory edge is not impressive. I was just sitting and debating clamping them in for a reprofile. Pretty sure I won't need the depth gauge ;)
Last Edit: 3 years 3 weeks ago by dschur.
The administrator has disabled public write access.

Re: What's the smallest blade you've done on the WEPS? 3 years 3 weeks ago #577

  • CAWalter
  • CAWalter's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 16
  • Thank you received: 3
  • Karma: 5
The Spyderco Honeybee, held by the jaw tips did a great job.

CAW
The administrator has disabled public write access.

Re: What's the smallest blade you've done on the WEPS? 3 years 1 week ago #683

  • leomitch
  • leomitch's Avatar
  • OFFLINE
  • Administrator
  • Posts: 723
  • Thank you received: 210
  • Karma: 92
I have done a small pen knife blade of 7/16ths of an inch (width), but at no steeper an angle than approximately 18 degrees. Beyond that, the paddles scraped the top of the vise. In order to do such a small blade, I had to clamp it as high on the spine as I could.
Hope this helps.

Leo
Never go anywhere without your knife!
Gibbs rule number 9

Leo James Mitchell
Last Edit: 3 years 1 week ago by leomitch.
The administrator has disabled public write access.

Re: What's the smallest blade you've done on the WEPS? 3 years 1 week ago #710

  • glenewertz
  • glenewertz's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 13
  • Karma: 4
Spyderco Ladybug

Glen
The administrator has disabled public write access.
Time to create page: 0.117 seconds