Welcome, Guest
Username: Password: Remember me

TOPIC: Backlit Cube! At last!

Re: Backlit Cube! At last! 1 year 7 months ago #9890

  • perminator
  • perminator's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
has anyone tried to add their own back lighting to their cube yet? im sure it wouldnt be hard ive added back lighting to other lcds before. im waiting on my pro pack 2 to arrive next week ill give it a try as soon as i can put the sharpener down long enough to tinker with it.
The administrator has disabled public write access.

Re: Backlit Cube! At last! 1 year 7 months ago #9898

  • cbwx34
  • cbwx34's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1260
  • Thank you received: 413
  • Karma: 92
Welcome to the forum! :)

Haven't tried this... if you do it, let us know how it goes!
The administrator has disabled public write access.

Re: Backlit Cube! At last! 1 year 7 months ago #9900

  • R.JeffreyCoates
  • R.JeffreyCoates's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 58
  • Thank you received: 22
  • Karma: 9
AN angle cube allows one to set the angle EXACTLY.

Here's how:

1. Set your knife in the sharpener and decide the angle (ie. 18 per side.)
2. Put the angle cube on the base of the sharpener and zero it.
3. Put the stone on the sharpening rod and set the pre-marked scale to 18 degrees.
4. Lay the stone against the knife as if you were going to start sharpening
5. Put the Angle Cube on the side of the sharpening stone that is not against the knife .....
6. READ THE ANGLE. It probably will NOT be 18 (due to inherent differences in the height of each knife
being sharpened.)
7. Adjust the angle until it reads 18 on the Angle Cube

You now have a true 18 degrees.
The administrator has disabled public write access.
The following user(s) said Thank You: wickededge, leomitch, cbwx34, Davidghemail

Re: Backlit Cube! At last! 1 year 7 months ago #9909

  • cbwx34
  • cbwx34's Avatar
  • OFFLINE
  • Moderator
  • Posts: 1260
  • Thank you received: 413
  • Karma: 92
The administrator has disabled public write access.
The following user(s) said Thank You: wickededge
Time to create page: 0.131 seconds