Welcome, Guest
Username: Password: Remember me

TOPIC: My first knife on the Wicked Edge

Re: My first knife on the Wicked Edge 1 year 7 months ago #7930

  • xuzme720
  • xuzme720's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 119
  • Thank you received: 28
  • Karma: 12
LukasPop wrote:
But this interests me. How do you solve touch ups? And when you buy new diamonds, how do you place them between existing worn off stones?
Best way I've found is to use a marker(sharpie) along the edge as an indicator so you can adjust exactly to the existing bevel. I know I'm not alone in this and it's a valuable tip for many sharpeners.

Just take a marker and run it down the bevel until you color the entire bevel black. Then its just a matter of a few strokes of the ceramics, adjusting your angle on the rods, until you can see the entire bevel is being hit by the stones(all the black is gone). HTH
Particpant in finding out how sharp is sharp!
Last Edit: 1 year 7 months ago by xuzme720.
The administrator has disabled public write access.
The following user(s) said Thank You: LukasPop

Re: My first knife on the Wicked Edge 1 year 7 months ago #7935

  • JamesBell
  • JamesBell's Avatar
  • OFFLINE
  • Senior Boarder
  • Posts: 65
  • Thank you received: 14
  • Karma: 9
I agree with you - full progression is quite time consuming.
As for touch up, mine varies, if it is a kitchen knife I look at the remaining edge and take my best guess what grit to start at, knowing I am not after a razor edge, just a good edge. If it is like my EDC which is a small Sebenza 21 I never let it get that dull, most of the time starting with 1200 / 1600. Ceramic 5K / 10K Choseras then strop it out.

Do want to Thank You for sharing your 8 month observations. You brought out some good points !

James
- James
The administrator has disabled public write access.
The following user(s) said Thank You: LukasPop
Time to create page: 0.126 seconds