Welcome, Guest
Username: Password: Remember me
Knife Photos
  • Page:
  • 1
  • 2

TOPIC: Acute angles on thick blade stock

Re:Acute angles on thick blade stock 7 months 1 week ago #16173

  • LeoBarr
  • LeoBarr's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 691
  • Thank you received: 239
  • Karma: 33
The way I did it is to work with the shallowest angle first and work it to the edge I did it on some Globals.
So 10Ëš through to the edge check for burr; then 15Ëšwith finishing stone then work back - 14Ëš-13Ëš-12Ëš-11Ëš then strop out the steps I did the stropping free hand you could then put a micro bevel on top of the 15Ëš bevel say 20Ëšwith the finest stone you have just do a couple of sweeps check with loupe it won't take much.
I should also mention that the high to low bevels will not need many sweeps just enough to create the bevels and should be done with finishing stones check with the loupe you will not be looking to remove much steel through these steps
The administrator has disabled public write access.
The following user(s) said Thank You: GibCurry

Re:Acute angles on thick blade stock 7 months 1 week ago #16180

  • mark76
  • mark76's Avatar
  • OFFLINE
  • Administrator
  • Posts: 1285
  • Thank you received: 420
  • Karma: 87
stephenleesharkey wrote:
I am just new to this online game. I typed in a google image search wicked edges, and man did I see some cool stuff. I am definitely going to try a convex edge on something I have that is thick. Would you guys recommend starting with the most accurate angle and going all the way to the apex with it, or would you recommend starting with the most obtuse angle? Would you guys recommend putting a micro bevel on a convex edge on a f thick blade?

See here for the pros and cons of the methods:http://moleculepolishing.wordpress.com/category/convex-edge/ (bottom 4 articles).
The administrator has disabled public write access.

Re:Acute angles on thick blade stock 7 months 1 week ago #16203

excellent. Thank you very much. I will definitely check that out.I'm not sure if you meant to put a link in my life section where you said check here for the pros and cons..... There was no link that showed up on my End , if that is the case.hand
The administrator has disabled public write access.

Re:Acute angles on thick blade stock 7 months 1 week ago #16204

I have bad eyes.... There is a web address but not the link. That is no problem I can just copy and paste thank you very much.
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 0.123 seconds