Welcome, Guest
Username: Password: Remember me
Welcome to the Wicked Edge forum!

Tell us and our members who you are, what you like and why you became a member of this site.
We welcome all new members and hope to see you around a lot!

TOPIC: Medford tff-1

Medford tff-1 3 months 2 weeks ago #17964

  • pepe
  • pepe's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
What angle would I use and placement for a Medford tff-1
Attachments:
The administrator has disabled public write access.

Medford tff-1 3 months 2 weeks ago #17966

  • razoredgeknives
  • razoredgeknives's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 860
  • Thank you received: 423
  • Karma: 41
Match the current angle that's on it... if you want a custom angle use an angle cube to determine exactly what angle you are wanting.

If this is your first knife I would wait a bit until you learn "How to find the 'sweet spot'"...
The administrator has disabled public write access.
The following user(s) said Thank You: wickededge

Medford tff-1 3 months 2 weeks ago #17976

  • Geocyclist
  • Geocyclist's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 464
  • Thank you received: 168
  • Karma: 31
Good advice, you normally can't go wrong with factory angle for starters. Depends on what you want the knife to do. I have taken some edges to 15 dps and found the steel can't handle it for my cutting tasks, so resharpened to 17.5 dps and all is good.

If this is your first knife definitely save it for later get cheap knife to practice on.
The administrator has disabled public write access.
Time to create page: 0.120 seconds