Welcome, Guest
Username: Password: Remember me
Welcome to the Wicked Edge forum!

Tell us and our members who you are, what you like and why you became a member of this site.
We welcome all new members and hope to see you around a lot!
  • Page:
  • 1
  • 2

TOPIC: An Introduction of Sorts

Re: An Introduction of Sorts 1 year 5 months ago #10717

  • JacobWilson
  • JacobWilson's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 17
  • Thank you received: 4
  • Karma: 0
mark76 wrote:
Welcome, Jacob! And nice table you've made. I've been thinking of building something similar myself. One reason I haven't done it yet is I thought it has to be heavy with thick legs in order to be stable enough and not wiggle. Your table/drawer seems to have quite thin and long legs. Is it stable enough?

It does wobble a little, and if you were to run into it accidently, it might just fall over. But for sharpening, it doesn't wobble nearly that much at all. Granted, my strops are not like Clay's--where they will lift the base--but I haven't had any trouble. There are also angled top plates you can use to angle the legs outward to provide better stability. For the $4 it cost, I might switch them out sometime later.
The administrator has disabled public write access.
  • Page:
  • 1
  • 2
Time to create page: 0.131 seconds