Welcome, Guest
Username: Password: Remember me

TOPIC: New rods and riser

Re: New rods and riser 2 years 3 months ago #3852

  • RalphHoneycutt
  • RalphHoneycutt's Avatar
  • OFFLINE
  • Junior Boarder
  • Posts: 25
  • Thank you received: 3
  • Karma: 3
Clay, Many thanks. I just wanted to know what I will be getting into. I placed my phone order with Kay a couple of weeks ago.

Ralph
The administrator has disabled public write access.

Re: New rods and riser 2 years 3 months ago #3854

  • wickededge
  • wickededge's Avatar
  • OFFLINE
  • Administrator
  • Posts: 1858
  • Thank you received: 691
  • Karma: 93
You're welcome Ralph. I'll be putting out a video in the next week or so showing how the new arms/joints work to try and answer some of the questions that will come up.
RalphHoneycutt wrote:
Clay, Many thanks. I just wanted to know what I will be getting into. I placed my phone order with Kay a couple of weeks ago.

Ralph
--Clay Allison
The administrator has disabled public write access.

Re: New rods and riser 2 years 3 months ago #3861

  • TarasShevchenko
  • TarasShevchenko's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 19
  • Thank you received: 3
  • Karma: 2
And what minimum angle will be achievable with this modification? If the angle offset is 2 degrees does it mean that minimum will be 13 instead of 15 per side?
The administrator has disabled public write access.

Re: New rods and riser 2 years 3 months ago #3863

  • wickededge
  • wickededge's Avatar
  • OFFLINE
  • Administrator
  • Posts: 1858
  • Thank you received: 691
  • Karma: 93
Hi Taras,

You're correct that the minimum will be 13 degrees per side on knives that extend 5/8" (15.875mm) above the top of the vise jaws.
TarasShevchenko wrote:
And what minimum angle will be achievable with this modification? If the angle offset is 2 degrees does it mean that minimum will be 13 instead of 15 per side?
--Clay Allison
The administrator has disabled public write access.

Re: New rods and riser 2 years 3 months ago #3866

  • TarasShevchenko
  • TarasShevchenko's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 19
  • Thank you received: 3
  • Karma: 2
Thanks for clarification
The administrator has disabled public write access.

Re: New rods and riser 2 years 3 months ago #3876

  • zig
  • zig's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 128
  • Thank you received: 38
  • Karma: 12
Question:
So Scandi grinds in the 10 - 11 field are out or is there a workaround?
www.zbsharpening.com
Knife Sharpening Service
This email address is being protected from spambots. You need JavaScript enabled to view it.
908-635-2748
The administrator has disabled public write access.
Time to create page: 0.131 seconds