Welcome, Guest
Username: Password: Remember me

TOPIC: Anyone know the asymmetrical angles on a Busse?

Anyone know the asymmetrical angles on a Busse? 1 year 7 months ago #4982

  • zig
  • zig's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 102
  • Thank you received: 19
  • Karma: 12
I'm wondering if anyone knows the angles on a Busse Battle Mistress, particularly the asymmetrical ones.

Wandering off of Wayne's chisel grind post, I was wanting to reprofile my ESEE's, at least 1 to check, and put on a Busse grind.

Problem is, I don't have a Busse :(

Anyone?

I did one already with the flat grind at 20, after reading the Emerson post was surprised it was as high as 30. The convex I did around 18, guessing from looking at pics of a Busse, but they are too close.
30 on the flat/chisel side would make its face smaller and more in line with what I see looking at a BM pic.
www.zbsharpening.com
Knife Sharpening Service
This email address is being protected from spambots. You need JavaScript enabled to view it.
908-635-2748
Last Edit: 1 year 7 months ago by zig.
The administrator has disabled public write access.

Re: Anyone know the asymmetrical angles on a Busse? 1 year 7 months ago #4983

  • zig
  • zig's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 102
  • Thank you received: 19
  • Karma: 12
Ahhh.... just noticed I forgot to move the directory and am in Welcome Mat :)

Any modes want to move it?
Sorry!
www.zbsharpening.com
Knife Sharpening Service
This email address is being protected from spambots. You need JavaScript enabled to view it.
908-635-2748
The administrator has disabled public write access.

Re: Anyone know the asymmetrical angles on a Busse? 1 year 7 months ago #4987

  • wickededge
  • wickededge's Avatar
  • NOW ONLINE
  • Administrator
  • Posts: 1714
  • Thank you received: 564
  • Karma: 90
Done. No problem!
zig wrote:
Ahhh.... just noticed I forgot to move the directory and am in Welcome Mat :)

Any modes want to move it?
Sorry!
--Clay Allison
The administrator has disabled public write access.
The following user(s) said Thank You: zig
Time to create page: 0.332 seconds