Welcome, Guest
Username: Password: Remember me

TOPIC: Bulk cheese knife

Bulk cheese knife 1 year 2 months ago #12985

  • EamonMcGowan
  • EamonMcGowan's Avatar
  • NOW ONLINE
  • Platinum Boarder
  • Posts: 525
  • Thank you received: 200
  • Karma: 29
A Pizza shop dropped of three knifes. The one that I'm not sure what to grind to is 15"x2.5 blade, Two handled knife used for cutting bulk cheese.

Any thoughts, suggestions?


Bulk Cheese Knife photo
The definition of insanity is to do the same thing over and over again and expect a different result?
An old Irish toast, May the wind always be at your back, may you always have work and may you be in heaven a half hour before the devil knows your dead. Cheers!
Last Edit: 1 year 2 months ago by cbwx34. Reason: Fixed photo link
The administrator has disabled public write access.

Bulk cheese knife 1 year 2 months ago #12990

  • mark76
  • mark76's Avatar
  • OFFLINE
  • Administrator
  • Posts: 1282
  • Thank you received: 416
  • Karma: 87
This is what we use in Holland for large cheeses (much larger sizes available..): www.kookwinkel.nl/webshop/48840-boskahol...staalzilverbruin.asp

I've sharpened a few of them, I think in a progression up to the 1600 grit ceramics at 20 degrees. I think next time I'll put a fairly large conex edge on it, since this may reduce the sticking of the cheese to the knife.
Last Edit: 1 year 2 months ago by mark76.
The administrator has disabled public write access.

Bulk cheese knife 1 year 2 months ago #12994

  • LeoBarr
  • LeoBarr's Avatar
  • OFFLINE
  • Platinum Boarder
  • Posts: 691
  • Thank you received: 238
  • Karma: 33
I have done one that was about a metre long I did it on an Edge pro . I see absolutely no reason why it should not be a synch on the WE I would hazard a guess that all you need to do is to clamp it in the centre perpendicular to the base it should be a lot less confusing than on the EP since both sides look the same and you are not turning it over .
The administrator has disabled public write access.
Time to create page: 0.125 seconds